Diameter: mm from 1600mm to 2400mm

Ring stiffness: from SN2 to SN16

Productivity: from 1 L/s to 190 L/s

Oil separators are designed to remove emulsified oil products and suspended solids from water supplied to rainwater treatment plants. It is used as part of local treatment facilities for surface runoff and as a separate stage of the coalescent separation of emulsified petroleum products, gasoline, fuel oil, organic and mineral oils, as well as filtration on sponge filters. The use of an oil and petrol trap makes it possible to remove residual suspension from the flow with a particle size of 0.05-0.1 mm, the content of which in the treated waste is 30-35%, and also to remove residual oil products with a particle size of up to 0.05 mm, the proportion of which after cleaning in a sand trap 10-15% of the total mass. Any design and construction company can contact our constructor department to receive robustness calculations of loads, calculations of the plate against ascent, selection of pumping equipment and many other technical services.

Diameter: mm from 1600mm to 2400mm

Ring stiffness: from SN2 to SN16

Productivity: from 1 L/s to 190 L/s

Sorption block BIOTOP is designed for deep purification of wastewater from oil products, suspended solids, heavy metals, reducing the level of BOD and COD to concentrations allowed for discharge into reservoirs or sewage systems. Water after the sorption block, if necessary, can be sent for UV disinfection. As a sorption load, an aluminosilicate sorbent with hydrophobic properties is used. The sorbent does not absorb moisture, which makes it easier to extract the used load. The service life of the aluminosilicate sorbent is about 2500 hours of rain.

Simple installation that does not require special qualifications from personnel.

The low weight reduces the complexity of installation and maintenance operations.

With proper operation, the body elements of polyethylene structures do not leak throughout the entire service life.

Polyethylene casing, due to their elasticity, easily tolerate temperature changes. Any design and construction company can contact our constructor department to receive robustness calculations of loads, calculations of the plate against ascent, selection of pumping equipment and many other technical services.

Diameter: mm from 1600mm to 2400mm

Ring stiffness: from SN2 to SN16

Productivity: from 1 L/s to 190 L/s

The BIOTOP-LOS complex system is designed to treat surface rainwater and snowmelt wastewater from oil products and suspended solids. The sorbent used in the system makes it possible to additionally remove contaminants such as iron, nickel, copper, zinc and chromium that enter the local treatment plant with infiltration water through old leaking sewer manholes. In addition, in combination with a multi-stage settling and sorption filtration system, the complex system allows you to reduce parameters such as BOD and active surfactants. The treated effluent can be discharged into collectors or reservoirs for various purposes, having undergone disinfection if necessary. The selection of a suitable treatment system configuration depends on the source of the wastewater and the place of discharge. The degree of cleaning is determined by government regulations, which include a number of established factors. Any design and construction company can contact our constructor department to receive robustness calculations of loads, calculations of the plate against ascent, selection of pumping equipment and many other technical services.